Here we advise you on how to clean the spray arms: Remove any excess water. Remove the dishwasher baskets so you have room to work. Give the spray arms a spin to ensure they're moving freely - visually check for cracks (paying extra attention to moulded joints). Take a close look at the spray arm water holes and check for obstructions. + Make sure the lid is fully closed. If it is, check if the lid switch is working. If the lid on a top-loader washer closed properly, the washer likely won't run. When a washer isn't Troubleshooting (see page 16) Possible causes/Solution: Problem The washer-dryer won't start. The wash cycle won't start. see page 11 The washer-dryer fails to load water. The washer-dryer continuously (see page 3) loads and unloads water. (see page 3) The washer-dryer does not (see page 10) drain or spin. Page 16: Service Ensure that the waste pipe of the washing machine is higher at one point than the drum of the machine, this will prevent water running back into the machine. Normally this would fill the machine with dirty water. Or it could be a faulty water inlet valve, which will fill the machine with clean water. To see if it is this close the washing Open the machine and shift the items around to balance the washing machine load, and your washer can spin more effectively. Adding more items to help balance a load can be effective, too, as long it doesn't overfill the machine. You'll probably know if your washing machine isn't balanced, because it will make a lot of noise and vibration as it Clean Water. If the water in the drum is clean it indicates that the inlet valve is faulty and is allowing clean water into your machine when it's not in operation. Dirty Water. If the water in the drum is dirty it indicates that the drain hose isn't working as it should. Please note: if you are not 100% confident with your abilities as an .

indesit washing machine not filling with water